Eastwood Spotweld Drill 3/8" Pro

3/8" cutter drills-out spot welds, with minimal grinding to finish.

Eastwood Spotweld Drill 3/8" Pro - EW19017

Solid steel Pro Spotweld Cutter effortlessly drills-out spot welds 1-piece cutter makes clean cuts through spot welds, without damaging the bottom panel.

▶   3/8" (10mm) diameter
▶   Solid, 1-pc. M2 steel
▶   Self-centering
▶   Over 300 cuts without sharpening

Professional-grade cutter totally drills-out spot welds, with little or no grinding required to finish the job. Solid one-piece cutter is machined from M2 tool steel. Self-centering point prevents "drill walking". Extremely durable and long-lasting—shop tested at over 300 cuts without re-sharpening. 3/8"-diameter cutter works for most applications. Drill at 700 to 2,000 RPM.

  • Great tool for the job!!
    I had one previously that seemed to be getting dull after maybe 25-30 cuts. Couldn't find it for this job (DOH!!), as it's been a few years, so I ordered another. Agree with others that it could be longer. BUT....nonetheless, it's the tool for the job!!
  • Works well
    I've used this bit on over 300 spot welds, and has done a fine job. You can get a bit extension at some hardware store, to get into tight areas. I've just ordered my second bit. but I will try to get the original one sharpened.
  • Good tool
    The drill does an excellent job cutting away the upper spot of the weld. The weld separates easily once the upper panel is drilled. The only downfall I experienced was the short length of about 1-3/4" inches. Once in the chuck it was difficult to have 1" of bit extending from the drill. Several times in close areas the drill chuck was too close to get the weld cutter onto the spot. The drill needs to be perfectly straight to drill. A length of 2-1/2" or longer would be nice.
  • Does removes spot welds
    Bought to remove floor pans in resto project. Clean surface and try to center as close as possible. Use center punch. Hard to tell how deep to drill and it's easy to drill all the way through. Practice on scrap to get the feel.
  • Good product
    This bit takes out spot welds with great accuracy and seems to hold the cutting edges well. It definitely needs to have a 1" longer shank, however, for tight spot welds.
  • Good cutter
    I have three of these and they work great .I use a 20v battery drill med. speed , punch first . And use a nonsilicone lube . Sharpen lightly with diamond stone .
  • It works
    Tool works well, and seems to be made well. Wish the shank was a little longer though.