Eastwood 8pc Dual-Cut Carbide Burr Set

Product Code:

EW11779

Excludes Courier Fee

Qty:

Shape and deburr quickly and accurately with Carbide Burrs These 8 carbide burrs are the preferred choice for precise metal removal when shaping, leveling, or porting cast iron, steel and other ferrous metals.

Double-cut and precision-ground for vibration-free operation in your 20,000-rpm die grinder. All burrs have a 1-1/2" long, 1/4" shaft. 90-day mfr's. warranty.

Product Code EW– 11779

Contents
2 cylindrical burrs: 1/2" x 1" and 3/8" x 3/4"
2 cylindrical/radius-end burrs: 3/8" x 3/4" and 1/4" x 5/8"
2 ball burrs: 1/4" and 3/8" diameters
2 cone/radius-end burrs: 3/8" x 3/4" and 1/2" x 1"

Share this product with Friends

Feedback

I wasn't expecting the quality and durability for the price, so was pleasantly surprised. Even the holding-case is nice, form-fitting with magnetic-latch. I punished a couple of these on inside-corner weld-beads, and metal-chips were just flying! No bluing (yet) either.
I purchased along with the 4 piece dual cut carbide set to port a cast iron MGA cylinder head. I used a variable speed drill rather than a die grinder. Bits are very sharp out of the box, and cut rapidly, especially the rough casting material. My criticism of these bits is that the shaft is too short. The 4 piece set had greater utility due to the longer reach. These are far superior to anything I've ever seen at the local hardware or big box stores.