Eastwood HotCoat Powder - Gold

The Rust Restoration Specialists !

Eastwood Hotcoat Powder Gold

Extremely durable, chip-resistant finish; coat and cure in under an hour.

Size: 1 lb Bag

Product Code: EW10163LB


Check out our Product Guide for Common Uses for PPC CO. Products on restoration projects.

ppcco tabs

Eastwood Hotcoat Powder Gold - EW10163LB

Do The Job Right with Eastwood Powders!

▶   Provides extremely durable finish
▶   Contains no environmentally harmful solvents
▶   100% Virgin powder
▶   Impact resistant and flexibility
▶   Good chemical resistance

Eastwood Powders are far superior to liquid coatings. They provide an extremely durable finish that is chip resistant. All Powders are formulated of the highest quality materials and are chemical and fuel resistant. Eastwood Powders are durable enough for under hood applications and heat resistant up to 250℉. They are suitable for any metal surface and most cure at a temperature of 400℉ at 20 minutes after flow out. With Eastwood powders, you can be assured of high transfer efficiency and brilliant colors.


CLEAN - Thoroughly strip and clean your metal part before coating. We recommend Eastwood Pre Painting Prep.

COAT - Apply using Eastwood DIY HotCoat Gun 11671A or the Eastwood Dual Voltage HotCoat Gun 11678.

CURE - Cure the part in an electric oven for recommended time. NEVER use an oven that is used for food.


Color: Gold
Gloss Level: Semi-Gloss
Cure Temperature: 400℉
Cure Time: 20 Minutes after flowout
Powder Type: Urethane
Finish: Smooth
Coverage: 1/2 lb. of powder is approximately 10-20 sq. ft.


When applying powder always apply it in a well ventilated area away from heat sparks and open flame. Always use a respirator rated for dust while applying powder. Always store powders in cool (less than 80 degrees Fahrenheit) dry (60 percent or less humidity) well ventilated area away from heat sparks and open flame.

Other Colours

Select Powder Range to see


Powder Coating Made Easy - Dual Voltage Powder Coating Gun from Eastwood

With our dual-voltage HotCoat gun, you can powder coat interiors and hard-to-reach corners using the low 15,000-volt setting, or switch to the high 25,000-volt setting for multi-coat coverage over larger areas with increased powder adhesion and minimal overspray. Either way, you'll get all the benefits of powder coating in your own shop!

Extremely durable finish
Coat and cure in under an hour!
Easy to apply
Quick color changes

  • Nice color but...
    It is almost a semi-gloss finish. I was a little dissapointed when I coated some springs, but the customer was happy and thats all that matters. The powder goes down grreat just like all of Eastwoods powders do. I would use it again, but now know to tell customers that it is not a high reflective powder and might have to go some place else for a high gloss. Also the gold is close to BBS gold, not exact but close.
  • correct color for honda motorcycles
    great product, the color is a perfect match for the rims on the Honda z 50 I am restoring, should match most mid 80's Honda stuff, like gold wing accents and hubs. the powder is a little light, I think due to the metallic in it, so it tends to be more dusty then say a simple black, so order a little more than you need as most stays in the air. Price is fair, but I think all of the powders here are about 3 dollars to much, but service and shipping make up a bit.
  • Good looking finish
    Bought this gold to do the rims on my race bike. Worked good and cured great. Had a problem with the powder clumping but they turned out good. I would recommend this product. It is a satin gloss.