Loading...

Eastwood HotCoat Powder - Super-Gloss Clear

The Rust Restoration Specialists !

Eastwood Hotcoat Powder Super-Gloss Clear

Extremely durable, chip-resistant finish; coat and cure in under an hour.

Size: 1 lb Bag

Product Code: EW10286LB

Quantity

Add to Cart

Check out our Product Guide for Common Uses for PPC CO. Products on restoration projects.


ppcco tabs

Eastwood Hotcoat Powder Super-Gloss Clear - EW10286LB

Do The Job Right with Eastwood Powders!

▶   Provides extremely durable finish
▶   Contains no environmentally harmful solvents
▶   100% Virgin powder
▶   Impact resistant and flexibility
▶   Good chemical resistance

Eastwood Powders are far superior to liquid coatings. They provide an extremely durable finish that is chip resistant. All Powders are formulated of the highest quality materials and are chemical and fuel resistant. Eastwood Powders are durable enough for under hood applications and heat resistant up to 250℉. They are suitable for any metal surface and most cure at a temperature of 400℉ at 20 minutes after flow out. With Eastwood powders, you can be assured of high transfer efficiency and brilliant colors.

Application

CLEAN - Thoroughly strip and clean your metal part before coating. We recommend Eastwood Pre Painting Prep.

COAT - Apply using Eastwood DIY HotCoat Gun 11671A or the Eastwood Dual Voltage HotCoat Gun 11678.

CURE - Cure the part in an electric oven for recommended time. NEVER use an oven that is used for food.

Specification

Color: High Gloss Clear
Gloss Level: High Gloss 95%
Cure Temperature: 375℉
Cure Time: 20 Minutes after flowout
Powder Type: Polyester TGIC
Finish: Smooth
Coverage: 1/2 lb. of powder is approximately 10-20 sq. ft

Safety

When applying powder always apply it in a well ventilated area away from heat sparks and open flame. Always use a respirator rated for dust while applying powder. Always store powders in cool (less than 80 degrees Fahrenheit) dry (60 percent or less humidity) well ventilated area away from heat sparks and open flame.

Other Colours

Select Powder Range to see

map
map

Powder Coating Made Easy - Dual Voltage Powder Coating Gun from Eastwood

With our dual-voltage HotCoat gun, you can powder coat interiors and hard-to-reach corners using the low 15,000-volt setting, or switch to the high 25,000-volt setting for multi-coat coverage over larger areas with increased powder adhesion and minimal overspray. Either way, you'll get all the benefits of powder coating in your own shop!

Extremely durable finish
Coat and cure in under an hour!
Easy to apply
Quick color changes
Economical

  • Very High Gloss
    I used this over the Silver Vein and the final product turned out beautiful. This clear produces a very glossy clear coat. I shoot it over the base color when the part is still hot and I have very good results. I'm tempted to try it over the satin black that I have been shooting mostly to see what the results would be? Don't hesitate to buy this clear for your project.
  • Takes a little getting used to applying this
    Had some issues at first, but they were operator error. First was I was baking it too hot, and second, I was putting to much on. I use about a 1/2 less powder then normal when applying the clear and I make sure my parts have cooled down to 375. Typically I leave the door open for a few seconds and turn the temp down and let it bake for 10-15min before I apply the clear. Have had great results since. This isnt as forgiving as the colors in if you put to much on it will pool in corners and will drip on bottom edges so you will want to test on a piece or 2