Eastwood Rust Encapsulator Flat Black 425g Aerosol

Product Code:

EW16060Z

Excludes Courier Fee

Qty:

Stop rust in its tracks! Our Rust Encapsulator has been reformulated with TWICE the corrosion resistance!

You thought it was good before...wait ’til you try this Rust Encapsulator! It seals and stops rust and corrosion from spreading, but it performs even better than our original formula. Tested against well-known brands, the Eastwood Rust Encapsulator has proven to be superior in sunlight resistance, preventing rust creep, and overall durability.

It is proven to be superior in sunlight resistance, preventing rust creep and overall durability. A great primer for floor pans and other under body parts.

Twice the corrosion resistance of our original formula for greater durability (tested to 500 hours in a salt-spray chamber)

Epoxy-fortified for better adhesion and topcoat compatibility

Penetrates deeper to prevent rust from spreading or forming, even in hard-to-reach areas

Cures faster, and is a low-VOC formula

It fills tiny pin-holes and surface irregularities and is compatible with lacquer, enamel and urethane topcoats

For absolute ultimate rust remedy use Metal Ready.

Heat resistant up to 205°C.

Part Number – EW-16060z

Share this product with Friends

Application
Use a wire brush to remove loose rust, scale and paint, and remove dust, grease and oil deposits. Wipe down with either Acetone or Pre Painting Prep (10041Z). Feather surrounding paint with 220-grit sandpaper. Shake can for at least 2 minutes once the mixing ball starts to rattle. Hold the Rust Encapsulator can 10-12" above surface as you spray. A single coat dries to the touch in 20 minutes, and is thoroughly dry in 3-4 hours at 68°F. For greater durability, a second coat can be applied 1 hour after the first. Allow 6-8 hours after the last coat before applying topcoat. Use over or under body fillers.

Safety
Work in a well-ventilated area when applying this product. The use of a respirator is recommended. Shake vigorously for 2 minutes before spraying.

(Q) Can Rust Encapsulator be applied with the Undercoating System?
(A) Technically, yes, but this application isn't recommended because Rust Encapsulator requires surface to be free of grease, oil, and loose rust. The best product to coat inside box sections is the Heavy-Duty Anti-Rust (16017ZP). This waxy, oily product flows into pinch welds and through rust to seal surfaces from contact with moisture and air, but cannot be painted over, so it's only suitable for inside box sections that don't show. Use lacquer thinner for cleanup.

Rust Encapsulator on My Classic Car from Eastwood

How To Stop Rust on Your Car, Truck, Tractor or Equipment with Eastwood Rust Encapsulator

Related Product