TopCoats - U-POL Acid #8 Etch Primer
U-POL Acid #8 Etch Primer
U-POL Acid #8 Etch Primer
The U-POL Acid #8 Etch Primer promotes paint adhesion to difficult substrates such as galvanised steel and aluminium. It is ideal for rub throughs in primer prior to application of colour and it features a fast drying formulation that does not require sanding.
U-POL Acid #8 is a linking coat which works in a similar way to Tie-Coat but dries in approximately 2 hours.
Application over cured POR-15 Rust Preventative Paint with a light coat, .allow to dry and then most paints / fillers can be applied directly onto it.
This saves sanding the hard POR-15.
It's available in either the handy 450 ml aerosol or 1lt normal cans.
PRODUCT INFORMATION | |
---|---|
![]() |
U-POL Acid #8 Product Information Sheet |
![]() |
U-POL Acid #8 1 Litre Product Information Sheet |
The information contained herein is based on data considered accurate and reliable to the best of our knowledge and belief as of the date compiled. However no warranty is expressed or implied regarding the accuracy of these data or the results to be obtained from the use hereof.
PRODUCT INFORMATION | |
---|---|
![]() |
U-POL Acid #8 Material Safety Data Sheet |
The information contained herein is based on data considered accurate and reliable to the best of our knowledge and belief as of the date compiled. However no warranty is expressed or implied regarding the accuracy of these data or the results to be obtained from the use hereof.
Used this to refurbish my alloy wheels.
Went on smoothly and didnt clog-up
this product works well and coats very evenly. very easy to use covers well with top coat. I would use it again..
The product was good and i liked that it was a spray.
Quite expensive but the best stuff especially in a aerosol. Several very light coats and your done.
Value for money. Very quick drying, nice finish after.